Yeti Cycles 575 '08-'09 Owner's Manual download pdf (Page 13)

Assembly Cont.

ASSEMBLY

Disassembly Tips

DISASSEMBLY

REAR TRIANGLE DISASSEMBLY

Loosen the pinch bolts at the top of

the seatstays.

At the seatstay junction, remove the Ti

male bolt on the non-drive side of the

frame from the 57.5 Ti stud with a 5mm

allen key.

REAR TRIANGLE DISASSEMBLY Insert the guide pin tool into the non

drive side of the 57.5 mm Ti stud and use a dead blow hammer to tap

the stud out of the frame. Be prepared to catch the stud as it exits the drive

side of the frame. Leave the guide pin in the frame during the next step.

REAR TRIANGLE DISASSEMBLY Remove the male main pivot bolt

from the female main pivot pin with a 5mm allen key. Use a punch

and a dead blow hammer to remove the main pivot pin from the swingarm

and front triangle. Tip: Brace the front triangle of the frame with your body

while removing the main pivot pin. This will help prevent any damage to the

front triangle and swingarm, and will allow for easier removal of the pin.

Tip: Use an adequate sized punch to prevent damage to the threads in the

main pivot pin.

SHOCK & DOGBONE DISSASSEMBLY

Remove the guide pin from the

seatstay junction and then pull the rear triangle off of the frame.

Remove the male bolt from the 40.5mm Ti female bolt holding the dogbone

in place. Use the guide pin and a dead blow hammer to tap the female bolt

out of the frame.

Repeat the process for the bolts holding the shock in place.

MOUNTING REAR TRIANGLE Prep an M6x1x12mm male Ti bolt with

locktite and install into the 57.5 mm Ti stud. Place the 57.5 Ti stud

and Ti male bolt assembly over the male portion of the Fox guide pin. Use

a dead blow hammer to push the bolt into place. Be prepared to catch the

guide pin as it exits the non-drive side of the bike. Install and tighten a Ti-

male bolt to the non drive side of the 57.5mm Ti stud with a 5mm allen key.

Check the alignment of the swingarm, dogbone, and shock.

Torque: 90-95 in/lbs

COMPLETE ASSEMBLY Ensure that there is equal spacing between

the bearings in the dogbone and the bearings in the seatstays on the

rear triangle. The shoulders of the two bearings on each side of the frame

should be pushed ﬂush against one another.

Torque the pinch bolts on the seatstays to 40-45 in/LB.

Torque the pinch bolts on the dogbone to 25-30 in/LB.

1 2 ... 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Yeti Cycles 575 '08-'09 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Bicycles Yeti Cycles 575 '08-'09