Yeti Cycles 575 2012 User Manual download pdf (Page 10)

Measure the appropriate amount of shifter housing. Once you have the housing measured start at the rear

derailleur and work your way forward on the bike. Zip tie the housing to the bottom of the drive side chain

stay and replace chain slap protector. Leaving a small amount of extra housing under the bottom bracket

to allow for suspension movement run the housing up the drive side of the housing mounts thr

eading the

housing through the loose zip ties that you placed when running the rear brake line. Run the cable around

the non-drive side of the head tube and to the shifter. Leave enough slack in the housing to allow the

handlebar to turn without binding.

Caution: The failure to properly route shifter housing can cause malfunction and unexpected shifting.

Measure the appropriate amount of shifter housing. Starting at the swing arm housing stop. Use the stop

closest to the drive side for Shimano derailleurs and the center cable stop for SRAM. Leave a little slack

under the bottom bracket to allow for suspension movement and work your way up the housing mounts,

threading the housing through the loose zip ties that were placed when you ran the rear brake line. Use the

center housing grove for the front shifter housing. Run the housing around the drive side of the head tube to

the shifter. Leave enough slack in the housing to allow the handlebar to turn without binding. Align all the

cables in their appropriate grooves and tighten the down tube zip ties.

The 575 uses full cable housing. By using full cable housing we have eliminated break points

in the line of your shifter housing. This reduces the entrance of unwanted elements such as

sweat and sediment into your shifting system. Use of full cable housing will keep your shifting

smoother for a longer period of time.

YETI TIPS

02. REAR DERAILLEUR

03. FRONT DERAILLEUR

The rear brake line runs on the inside of the non-drive side chain stay. If you have the option on your brake

adjust the “banjo” to create as clean a line to the rst housing mount as possible. Zip tie the line to the rst

housing mount. Follow the chain stay to the housing mount on the bottom of the chain stay and zip tie it in

place. Leaving enough slack in the line to allow for suspension movement run the line up the bottom of the

down tube. Very loosely zip tie the line in place up the non-drive side housing mount groove. The loose zip

ties will allow you to thread your shift lines through.

01. REAR BRAKE

20. 21.

CABLE SETUP

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Yeti Cycles 575 2012 User Manual Page 10